Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

  1. Host Files

    1. The IP address and node name need to be configured in the host file, as seen below, unless the Node name and the computer name are exactly the same.

    2. Go to notepad > Right Click “Run As Admin” > Open > C:\Windows\System32\drivers\etc> Check from Text files to All Files > hosts.

    3. If you’re trying to connect to a redundant pair, both node names and IP addresses for the primary and secondary server need to be in the hosts file on the client side.

    4. The client IP address and node name, need to be configured on both the primary and secondary.

Image RemovedImage Added

 

2. SCU file

  1. On the Client, go into your SCU > Network > Remote Node Name > NODE NAME > Add.

    1. If connecting to a Redundant SCADA, the logical node name will need to be entered.

  2. Save, exit and restart. 

 3. Other project files

  1. Pictures (.grf files) can be added to the client.

  2. Security files (if any) can be exported from the SCADA server and imported into the Client.